transfer case crossmember

circleburner12 · Post by **circleburner12** » Sun Sep 18, 2011 6:51 pm

cleaning the crossmember on the m38a1 and notice the rubber mount was too bad to reuse. got it out and notice a cup was welded to the crossmember and appeared to be another cup that the mount set in.

?- does anyone have a illustrated breakdown or picture of this crosmember? thanks for any info

Oldsalt · Post by **Oldsalt** » Sun Sep 18, 2011 10:39 pm

All of the crossmembers have that transfer case mount and the mount kit is readily available on the MV parts websites. Here is a link to one on Walcks.
http://walcks4wd.com/transfer-case-moun ... -d-18.html

circleburner12 · Post by **circleburner12** » Mon Sep 19, 2011 1:43 pm

thanks oldsalt, im taking it that the cup that is spot welded to the crossmember stays on and some how i need too get the other cup that had the rubber mount in it, out of the welded cup?

done of the manuals i have show the breakdown of the crossmember, so thanks for all the info.

RICKG · Post by **RICKG** » Mon Sep 19, 2011 1:48 pm

Circleburner, i've got a used trans mount set if you're
interested i'll get pics..

circleburner12 · Post by **circleburner12** » Mon Sep 19, 2011 5:55 pm

after cleaning the rust and parts of the rubber mount out of the cup i seen how it was. it reminded me of a race for a bearing, with some wd40 and a hammer it came out. thanks for the info guys.