master cylinder heat shield

Raider2532 · Post by **Raider2532** » Thu Jul 12, 2012 1:57 pm

I have a master cylinder heat shield that I would like to put on my M38A1, but I can not figure out how/where the shield attaches. It only has two brackets that almost looks as if it slides on somewhere underneath or beside the master cylinder. Any advice or any pictures available? Thanks

evanso1975 · Post by **evanso1975** » Thu Jul 12, 2012 2:28 pm

This post should help:
http://www.willysmjeeps.com/v2/modules. ... eat+shield

Note the moderator's comments on the photos near the bottom of the page, though. Page 240 of the ORD 9 might help too.

I'm guessing you have the stock M38A1 heat shield, like this:

If not, maybe you can post a photo of what you have?

Owen.

Headcase · Post by **Headcase** » Thu Jul 12, 2012 7:37 pm

Yes they are all correct and you do not have to take the bolt all the way out although if its a body off it's way easier. Loosen the bolts enought to slip the shield brackets over the shaft of the bolt on either side and re tighten. It is a pian if you are doing this from under the jeep with the body on.