Parts For Sale Updated w/a few small parts..

RICKG · Post by **RICKG** » Sat Jan 05, 2013 1:14 pm

24V starter MCZ4001UT spins good $80 **SOLD**

4260 AC fuel pump for core $30

Reg-Gen cable 36" $30 **SOLD**

Inst Panel Spider wires still supple $15

Aux Slave Receptical Pos cable 32" neg cable 12" $45

Outer dist cap for 24V waterproof dist (takeout) $10

Clutch cable w/clevis no clevis pin $15

F-134 intake crossover tube-clean $35

Aftermarket twin belt w-pump slightly used $25

Clutch/brake arms $20/pair

X-fer case shift levers $20/pair

1/2" mil fuel pump spacer w/(1) spec bolt 3-1/8" $20

Thx to all who have responded thus far..
Fotos available on request..

All Prices + Shipping be sure i'll ship best way or your preference.
PM if interested.. Rick

Kendall · Post by **Kendall** » Sat Jan 05, 2013 1:53 pm

I'm interested in the slave cable. How long are the cables? Is it the correct one for the M38?
Thanks,
Kendall

RICKG · Post by **RICKG** » Sat Jan 05, 2013 2:22 pm

It will work for the M-38 but i wouldn't call it correct. The long+ is 32" and
will reach the pos starter pole. the short- is 11" and will ground to the hole
in the fender where the cable clamp would be. To be correct the neg lead would be closer to 30" and bolt the the front starter mount support.
It mounts up clean but if
you're after a factory resto it's not for you..

lajhune · Post by **lajhune** » Sun Jan 06, 2013 9:33 am

pm sent for gen to reg cable & spider cable

acengraver · Post by **acengraver** » Sun Jan 06, 2013 10:26 am

PM sent for starter motor.

lajhune · Post by **lajhune** » Mon Jan 28, 2013 2:19 am

thanks for the gen to reg cable Rick..... till next time.

kbjeepin · Post by **kbjeepin** » Mon Jan 28, 2013 4:04 pm

still have cross over tube?

RICKG · Post by **RICKG** » Tue Jan 29, 2013 8:13 am

kbjeepin wrote:still have cross over tube?

Yep!! I'll PM fotos later today if you like. Rick

kbjeepin · Post by **kbjeepin** » Tue Jan 29, 2013 1:05 pm

please I am interested