I'm going to fabricate some stuff

Deadguy · Post by **Deadguy** » Sun Jan 06, 2013 12:51 pm

and if anyone has them, I need dimensions!
I'm going to make the winch mount for a military Ramsey 50 PTO. Just the front part that sits on the bumper! I'm also going to make the PTO "lock lever" that holds the winch lever in place. I know Wes already posted something with the dimensions for the frame, but I can't find them!

Bill_F · Post by **Bill_F** » Sun Jan 06, 2013 1:56 pm

I believe Joe from Vintage Wiring of Maine has reproduction of the lock for the pto already

Post by **wesk** » Sun Jan 06, 2013 2:05 pm

Go to my photo gallery: http://www.willysmjeeps.com/v2/modules. ... _album.php

Go to 2nd page.

Click on the "Winch" album

Click on the Album "Ramsey 50/50R Winch System

Then copy the drawings for the brackets

Then click on the album "Ramsey 105 PTO" and copy the illustrations there.

Deadguy · Post by **Deadguy** » Sun Jan 06, 2013 6:03 pm

Thanks Wes! I shot Joe from Vintage wiring an email.

flightmap · Post by **flightmap** » Tue Jan 08, 2013 9:42 am

Would you be interested in fabricating a hanger bearing and shaft for the winch? Would buy one if reasonable

Ken

ECVJeeps · Post by **ECVJeeps** » Tue Jan 08, 2013 10:47 am

The front section of the frame is 2" x 2" x 1/4" "T" stock, that is the hard part to find. The rest is just standard stock.

Deadguy · Post by **Deadguy** » Wed Jan 09, 2013 6:57 pm

yes, flightmap, I would definitely buy one if reasonable. Shoot me an email at dan@danhenk.com!

I'm going to fabricate some stuff

I'm going to fabricate some stuff

Fabrication