carburetor throttle shaft

Cacti_Ken · Post by **Cacti_Ken** » Sat Jan 26, 2013 9:24 pm

What would be the tap for the screw holes where the throttle valve goes? I broke off the screw. I was able to drill down the center of the screw. I haven't damaged the threads yet. I need to tap the remaining brass out.

I think it is a 3-48 but not sure.

Post by **wesk** » Sun Jan 27, 2013 12:17 am

3-48 is what is listed in the parts manual on page 68 for those two screws.

Bretto · Post by **Bretto** » Sun Jan 27, 2013 7:51 am

Are you rebushing your throttle body as well? If so, I'd like to see.

Cacti_Ken · Post by **Cacti_Ken** » Sun Jan 27, 2013 8:39 am

Thank you Wes,

Bretto wrote:Are you rebushing your throttle body as well? If so, I'd like to see.

I don't have plans to rebush the body. I don't feel any play in it.