M-38 Y-S Carburerator 637S

M-38CDN · Post by **M-38CDN** » Wed Apr 17, 2013 5:13 pm

My kit came with a new "Low-speed jet tube" witch goes in the bleeder tube and seems to be press fit in the air horn.
The rebuild instruction download don't mention this part. How do we remove this jet tube and fix a new one without braking anything?
Gaétan

Post by **wesk** » Wed Apr 17, 2013 8:21 pm

It is usually a simple pull and push deal. Measure your height of exposed tube before you pull it and then press the new one in to the same height. We just discussed this a few months ago but I can't seem to locate the thread.

M-38CDN · Post by **M-38CDN** » Thu Apr 18, 2013 6:11 am

Thanks Wes. I did not forget the photo of the winch drive shaft.
Gaétan