Measurements - M38 ax ubolt

Texbillhs · Post by **Texbillhs** » Mon Jun 10, 2013 6:34 pm

I'd be happy if someone would measure the distance apart the holes are for the ax ubolt. I am going the make one - should be a simple bending and threading job - I have a good picture, except I don't have the dimensions.

Bretto · Post by **Bretto** » Tue Jun 11, 2013 4:25 am

Check out page 10 on RickG photo page. He was kind enough to take some measurements for me at the time I made mine.

http://www.willysmjeeps.com/v2/modules. ... hp&page=10

It needs to be about 1" longer though than what is shown.
Here is my post when I made mine.

http://www.willysmjeeps.com/v2/modules. ... hlight=axe

Texbillhs · Post by **Texbillhs** » Tue Jun 11, 2013 6:02 am

thanks - as mentioned in the past, this site is worth its weight in gold

RICKG · Post by **RICKG** » Tue Jun 11, 2013 7:49 am

Bretto wrote: It needs to be about 1" longer though than what is shown.

Turns out the bracket i dimensioned was a cheesy repop
that's too short-be sure to add the extra length

Texbillhs · Post by **Texbillhs** » Tue Jun 11, 2013 9:20 am

I will add an inch