electrical system, M38A1

dave · Post by **dave** » Mon Jul 17, 2006 5:02 am

trying to install 100 amp system in M38A1, can't figure out leads #10 and 12. they should be batt supply, and ignition. Where do they tie in to system? Dave, N2XYP, sfc e-7, ret.

OKCM38CDN · Post by **OKCM38CDN** » Mon Jul 17, 2006 9:39 pm

Dave,

You need to move this post to the Technical Forum... You will get more answers there...

This Section is for issues with this web site... FYI...

petesilfven · Post by **petesilfven** » Fri Jul 21, 2006 2:52 pm

The number 10 wire is spliced to the number 10 wire at the connector for the original generator regulator, and the number 12 wire goes to the number 12 wire behind the instrument panel. I have the installation manual if you need it.

dave · Post by **dave** » Thu Aug 03, 2006 1:16 pm

do I leave the old regulator in place?

petesilfven · Post by **petesilfven** » Thu Aug 03, 2006 1:43 pm

No, the new one takes its place.