Oil pan skid plate
-
leecarr
- Contributor
- Posts: 54
- Joined: Sun Jul 14, 2013 6:00 pm
- Location: Rochester, Massachusetts
Oil pan skid plate
Other than the skid plate, is a civilian oil pan the same as an M38? If so is there any place I can get dimensions of the skid plate soI can make one? Also if I could get dimensions for the trans. skid plate I could make one of those.
-
jimm
- Active Member
- Posts: 202
- Joined: Mon Oct 31, 2011 6:00 pm
- Location: Escondido, CA
Re: Oil pan skid plate
If you're patient and don't get a better offer, I can make you drawings based on the plates on mine. I have the chassis restored, with the trans plate bolted on, and the engine out with the oil pan currently about an inch off the ground, so I'd have to hoist it up to get the measurements. PM me if you don't get what you need from someone else.leecarr wrote:Other than the skid plate, is a civilian oil pan the same as an M38? If so is there any place I can get dimensions of the skid plate soI can make one? Also if I could get dimensions for the trans. skid plate I could make one of those.
Jim McKim
1952 M38 son-father project
Slowly turning rusty parts into OD parts
1952 M38 son-father project
Slowly turning rusty parts into OD parts