m38 belcrank problems

henrydes · Post by **henrydes** » Sun Feb 16, 2014 11:40 am

I have tried to install the seals on the bell crank two times with little sucess, having bent,crushed, or scraped the rubber off the seal on four of them I think it time to look for help. Has anybody out there ever accomplished this and if you did how did you do it. Any advise would be appreciated.

Post by **wesk** » Sun Feb 16, 2014 11:56 am

Start by making sure you have the correct pieces. There are three different size bellcranks and a military sealing/boot system and a civvy unsealed system.

Use the search function here to see some of the earlier posts on this same topic. Here's a couple.

http://www.willysmjeeps.com/v2/modules. ... =bellcrank

http://www.willysmjeeps.com/v2/modules. ... =bellcrank