rear engine plate

aforests · Post by **aforests** » Tue Jul 28, 2015 11:20 am

take a look at my rear engine plate. first of all, the new gasket I got does not seem to match up to the holes very well. secondly, when I try to mount it, it seems like the attached metal strip is not allowing the plate to line up with the holes on the engine. Any ideas?

Post by **wesk** » Tue Jul 28, 2015 11:33 am

Your new gasket has shrunk.

Try leaving the angle loose when installing the adapter plate.

The gasket is only needed if you intend to ford the jeep!