“just remember the anti seize when installing the distributor.”
Thanks for the heads up.
What areas get anti seize in addition to the LPS2 & Artillery Grease?
M38 Distributor Rebuild
Moderators: TomM, Moderator, wesk
-
RonD2
- Member
- Posts: 2065
- Joined: Wed Oct 01, 2014 6:00 pm
- Location: South Carolina, Dorchester County
Put some anti-seize on the area labeled in this photo as "the area that corrodes and sticks in the engine block".
Doesn't take much. A little with your finger of choice inside the top inch or so of the boss on the block and a little around the shaft in the area shown in the photo.
Give it a twist or two after you drop it in the hole, before you lock it down (after adjusting the timing).
Doesn't take much. A little with your finger of choice inside the top inch or so of the boss on the block and a little around the shaft in the area shown in the photo.
Give it a twist or two after you drop it in the hole, before you lock it down (after adjusting the timing).
Ron D.
1951 M38 Unknown Serial Number
1951 M100 Dunbar Kapple 01169903 dod 5-51
“The only good sports car that America ever made was the Jeep."
--- Enzo Ferrari
1951 M38 Unknown Serial Number
1951 M100 Dunbar Kapple 01169903 dod 5-51
“The only good sports car that America ever made was the Jeep."
--- Enzo Ferrari
Excellent. 
