mutt wheels

bfr · Post by **bfr** » Sat Jul 14, 2007 10:56 pm

will mutt wheels fit on a m38a1/m170? just looking for cheap rollers to use during restoration

Post by **wesk** » Sat Jul 14, 2007 11:07 pm

Center hole is too small. You can cut it out but that will weaken the wheel. Some early (1960 thru about 1979) Ford F150 4WD pickup wheels will fit.

maeserik · Post by **maeserik** » Mon Jul 16, 2007 1:20 pm

Before prevouis owner dismantled my jeep, the one i restored i think there were mutt wheels at the back....

possible they fit at the rear axle not at the front axle ?

Erik

Post by **wesk** » Mon Jul 16, 2007 1:42 pm

The center hole of the 151 wheel is too small for the front hubs. The wheel offset also causes interference issues with the fenders.