Unidentified M38 part

Bertram · Post by **Bertram** » Wed Dec 07, 2022 9:02 pm

Does anyone know what this is or where is goes on my M38 ? I forgot to label it. I know it came off near the cross member. There are two one for left and right I think as they are opposites. Thanks!

4x4M38 · Post by **4x4M38** » Wed Dec 07, 2022 9:51 pm

They go on the engine to bell housing plate in the forward side.

http://willysmjeeps.com/v2/modules/gall ... sized.jpeg

Bertram · Post by **Bertram** » Thu Dec 08, 2022 7:28 pm

Awesome!!!! Thanks Brian….I have one more for you. I’m looking for the gasket that goes around the neck of the Ross 15/16 stealing box top. Here is a pic above.

Bertram · Post by **Bertram** » Thu Dec 08, 2022 7:30 pm

Some sort of gasket was attached to it when I pulled the shearing tube out but I can’t seem to find it in the ORD Manual

RonD2 · Post by **RonD2** » Thu Dec 08, 2022 8:15 pm

Gasket or metal shim.
Shims are available from the vendors.
Might have to make the gasket.
See Figures 14-2 and 14-3 on pages 258 and 259 of the ORD9 manual.

Good luck!

Bertram · Post by **Bertram** » Thu Dec 08, 2022 8:53 pm

Some sort of gasket was attached to it when I pulled the shearing tube out but I can’t seem to find it in the ORD Manual

RonD2 · Post by **RonD2** » Thu Dec 08, 2022 9:23 pm

Gasket is listed and shown in the ORD9 figure I gave above.

Post by **wesk** » Thu Dec 08, 2022 9:47 pm

Caution: The steering box pictured on page 258 Fig 14-2 does not show a gasket but page 259 Fig 14-3's later steering column does.