M38a1 Carb flooding and Im out of ideas

Discussion topics on Willys Overland M series vehicles
Post Reply
User avatar
RichJohnson
Active Member
Active Member
Posts: 163
Joined: Thu Apr 14, 2005 6:00 pm
Location: San Diego CA
Contact:

M38a1 Carb flooding and Im out of ideas

Post by RichJohnson »

So two weeks ago I went to drive my jeep after one week of sitting parked. She had been running fine.
Idling to warm up she started puffing black smoke and choked and died. I opened the hood and found fuel coming out of the carb top screws.
Float stuck right...

So I pull just the air horn and yeah the needle and seat were a little sloppy side to side as I have never replaced them even while overhauling the carb every couple years. So I used a magnifier and could see a wear ring on the needle so I replaced just the needle and seat but reused my push pin and spring and then reset the float tab to have the float rest 1/4 icnh above the air horn lid while inverted per the diagrams in the tm.
(I should note, the new needle, which is the square shaft with needle on top and the hole inside it, the hole cavity was deeper than the prior(government one), and the spring and pin sit inside it further, that was why I had to readjust the float tab)

The jeep started and idled but still smoked quite a bit.
So my friend suggested it was time to change the two diaphragms on the throttle circuits out so I got new ones from the guy on ebay and changed just those.

Then it ran worse and will not idle unless I screw the air fuel mixture idle screw al the way in and even then it still has black smoke.

I started to think the float is still not putting enough pressure on the needle to close off the fuel all the way and it could still be flooding so I added more bend to the float tab up to 5/16 and tried that.
It is still the same situation. She idles way too rich to really run.

I have generally done fairly well at keeping the carburetor in running shape over the years but now Im stumped. Ever since the float stuck its like i cant get it back to a normal setting.

What suggestions can you guys offer me? More bend on the tab to increase float pressure on the needle? Something else?

Oh also, I have a plastic clear fuel filter about 10 inches in front of the carb to prevent junk from getting in it, only mod I have made and boy has that resolved past problems.
"Those who enjoy freedom must endeavor to preserve it"

KI6EZA
1954 M38A1 (first civilain owner)
1965 M37B1 Commo shelter truck
MBT
GRC-122 TTY rig
Post Reply