Bell crank and rebuild parts

85jeepcj · Post by **85jeepcj** » Mon Dec 24, 2018 4:08 pm

Correct I was looking for steering bellcrank.
My problem is I have NOS M38 bellcrank and I can only find crappy foreign made parts for it. The problem is the 7/8 x 1 1/4 spacer is too short in length
This causes the bellcrank to bind up unless I machine some material from the new bellcrank. Also I would rather have the cotter pin type nut method to secure the nut from backing off.
So what I need is NOS hardware that was correctly made back in the day.
I’ve seen the tapered roller bearing setup and I do believe that is an improvement.

Post by **wesk** » Mon Dec 24, 2018 8:17 pm

Ron, I have several early. If you can't find one let me know.

RonD2 · Post by **RonD2** » Mon Dec 24, 2018 9:05 pm

Wilco! And thanks, Wes.

With my apologies for hi-jacking the thread!