Fuel, vent & vacuum lines

Cacti_Ken · Post by **Cacti_Ken** » Wed Apr 19, 2006 7:23 pm

What are the outside diameters of the fuel, vent, and vacuum lines? I'm hooking up the fuel pump to carburetor first then I'll go from there. also I am making them. Does anyone have a list of what connectors are needed?
I can get some idea from the manual, but not for all.

BobW · Post by **BobW** » Wed Apr 19, 2006 8:10 pm

I have a database of vent system parts located here...
http://www.cj3a.info/sibling/m38vent/vent4.htm
It should have every part of the vent system which includes some vacuum parts. The lines are called tubes or lines in the parts manuals. The diameter and length should be listed for each line.
The complete vent system article is here...
http://www.cj3a.info/sibling/m38vent/vent.htm

Cacti_Ken · Post by **Cacti_Ken** » Thu Apr 20, 2006 9:09 pm

Wow!! Bob, you put a lot of work into that list.
thanks.

Ken

OKCM38CDN · Post by **OKCM38CDN** » Fri Apr 21, 2006 4:16 pm

Seeing if I can post to this topic...

Have tried several times and no go...

Post by **wesk** » Fri Apr 21, 2006 11:21 pm

Hal,
You have to log on first.

OKCM38CDN · Post by **OKCM38CDN** » Sat Apr 22, 2006 6:49 am

Will not take anything but a one line entry... and the welcome at the top says I am logged in. this is the only post I cannot post to...

Post by **wesk** » Sat Apr 22, 2006 7:34 pm

OKCM38CDN wrote:Will not take anything but a one line entry... and the welcome at the top says I am logged in. this is the only post I cannot post to...

That's a two line entyry right there. Your messages are clearly posting.