fuel sending unit

RichJohnson · Post by **RichJohnson** » Wed Apr 27, 2005 9:30 pm

In My m38a1 I had to install a tank when I got it years ago because it didnt have one. I just got it runningand found that the gas sender is really off. I tried to adjust it by bending the rod to the float. It is really long and the tanknwont register full I have managed to get it accrate at the bottom before I run out of gas but thats it. How long is the rod to the float supposed to be. I think that when I bought it I was supplied with the wrong one. Also is fuel supposed to come out the filler cap when I make turns. The cap is new too

RichJohnson · Post by **RichJohnson** » Mon May 02, 2005 12:02 am

Cant any body answer these questions?
Is gas supposed to come out the filler cap on a turn when the tank is full?
How long is the float arm on the fuel sending unit for an M38a1 supposed to be?

kenperkins · Post by **kenperkins** » Mon May 02, 2005 9:16 pm

I have what I believe to be 2 m38a1 senders, their 5.5 inches from center of float to piviot
are you running a vented gas cap?
does gas tank have a vent? or cloged vent line?

RichJohnson · Post by **RichJohnson** » Tue May 03, 2005 12:04 pm

My tank has a cone shaped vent on top and the gas cap is set to open vent.

willysmjeeps.com

fuel sending unit

fuel sending unit

fuel vent