Technique for camshaft gear removal

Kendall

I am attempting to remove the camshaft gear from L-134, M38 engine. Been reading TM 9-1804A, but without the special puller I am having trouble getting other gear pullers to work. Any suggestions? Also, where are the timing marks on the gears that are mentioned in the Note on the bottom of page 47 in same manual? Thanks for your help, Kendall

wesk · Posted: Fri Dec 22, 2006 7:22 pm Post subject:

Any attempt at prying against it's rim will result in a broken gear. Get the correct puller or buy a new gear.

Timing marks are very small dots. The crank gear dot is at the bottom of a space between two teeth and the camshaft gear dot is right on the front of one tooth.
_________________
Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100

Mjeeps photo album: http://www.willysmjeeps.com/v2/modules.php?set_albumName=Wes-Knettle&op=modload&name=gallery&file=index&include=view_album.php

gorzel · Posted: Sun Dec 24, 2006 5:27 pm Post subject:

Where can you get the correct puller?
_________________
Michael G.
51 M38 MC 30497 (just starting)

wesk · Posted: Sun Dec 24, 2006 6:27 pm Post subject:

Snap-On, OTC, Proto, Northern Tool and etc,

A push / pull type puller kit that comes with both bolts and flange legs ''

_________________
Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100

Mjeeps photo album: http://www.willysmjeeps.com/v2/modules.php?set_albumName=Wes-Knettle&op=modload&name=gallery&file=index&include=view_album.php

gorzel · Posted: Sun Dec 24, 2006 11:43 pm Post subject:

OK. Just a regular puller. Not a Jaw puller. Good I have it already.

Thanks
_________________
Michael G.
51 M38 MC 30497 (just starting)


Create an account	Home · · Forums · · Articles · · Downloads · · Photo Gallery


PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.