Joined: Nov 25, 2007 Posts: 56 Location: Marietta, Georgia
Posted: Tue Feb 12, 2008 3:01 pm Post subject: Diff Spreader
Does anyone have plans on how to build a diff spreader like the one shown below? I have some 1.5 x 0.5 inch bar stock I can use, and I can probably make something that will work, but wanted to see if someone had plans.
I've removed the carrier without a spreader many times. Just made sure the housing was warm and used a pry bar. Local fabrication would be quite simple. Just make an pair of angles or strap fasten to each side and provide any means of pushing them apart. A couple of simple machinist screw jacks will work. You're only spreading this a few .001's. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
I used a propane heater/blower to heat the case up. I pried the gear out with out the heat ok with a large pry bar, but I had to put some heat on it when I was trying to get the bearing races to fall in place. _________________ Tropical Veteran
35th Inf. Reg. "CACTI" 4th I.D. VN
Amateur Radio K5XOM
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum