Location of Spare tire M38/A-1 ???
-
TrafficCzar
- Member
- Posts: 6
- Joined: Sun Jul 13, 2008 6:00 pm
Location of Spare tire M38/A-1 ???
- PaulK
- Member
- Posts: 37
- Joined: Fri Jun 01, 2007 6:00 pm
Spare tire location
Hey Czar,
I dont think you have an M38A1. If you did theres a palce for the spare tire holder on the right hand side when you are facing the back of the jeep. If I were you I would look around on the here and on the G503 and figure out which jeep you have and then ask for a pic of the back side.
Good luck,
Paul
I dont think you have an M38A1. If you did theres a palce for the spare tire holder on the right hand side when you are facing the back of the jeep. If I were you I would look around on the here and on the G503 and figure out which jeep you have and then ask for a pic of the back side.
Good luck,
Paul
- wesk
- Site Administrator

- Posts: 16471
- Joined: Sun Apr 03, 2005 6:00 pm
- Location: Wisconsin
- Contact:
The M38A1 did not come from Willys with a tailgate. It had a solid rear panel across the back with the a special spare tire bracket that placed the tire higher then the the CJ's did. It was on the passenger side of the rear panel. The gas can carrier was on the driver's side of the rear panel.

This is the rear panel of an M38A1

This is the spare carrier for the M38A1.

This is the rear view of a 1967 CJ5

This is the rear panel of an M38A1

This is the spare carrier for the M38A1.

This is the rear view of a 1967 CJ5
Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Mjeeps photo album: http://www.willysmjeeps.com/v2/modules. ... _album.php
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Mjeeps photo album: http://www.willysmjeeps.com/v2/modules. ... _album.php
-
TrafficCzar
- Member
- Posts: 6
- Joined: Sun Jul 13, 2008 6:00 pm
Thanks
Thnks for the picks. Data plate does show that it is in fact a M-38/A-1, "Tailgate" was insalled with 4 bolts, did not actually move. I can seefrom the photos that the previous owner rotated the spare tire bracket 90 degrees, which centered the spare tire. Now I can install it properly. Thanks again