bell housing

johnsfind53 · Post by **johnsfind53** » Thu Dec 04, 2008 9:05 pm

Me again, the knowledge freak. I'm wondering if one of you guys could tell me the size of the hole at the bell housing, where the bell meets the transmission.
Thanks in advance
John

Post by **Ryan_Miller** » Sat Dec 06, 2008 8:57 am

John,

Are you talking about the overall width of the bell?

Just clarifying, I was not sure.

johnsfind53 · Post by **johnsfind53** » Sun Dec 07, 2008 3:08 pm

where the input bearing retainer fits through the bell housing. example would be a gm truck bell has a five and one quarter inch hole.

Post by **wesk** » Sun Dec 07, 2008 6:17 pm

4.25"