Top Bow, "rings, chains and pins"

[DougK]

I posted this on the GEE but thought I might catch an answer over here for those that don't get to the GEE.

I have just installed the windshield brackets that hold the rods from the top bows. I have also made the rods from the schematic on David Pizzaferrato's OD site.

Now the question. Does anyone have more detailed information than what the Ord 9 states as " 2 chains, 2 pins and 4 rings" for the method of holding the front of the rods in the windshield bracket?

I have left over chains and rings from MV Spares that I bought some time ago that I used on the passenger front seat pivot brackets. Are they correct for the application on the top bow rods? If so what would one use for pins? Cotter pins? Since I am asking, are the MV Spares correct for the seat pivot brackets?

Any detailed photos of NOS or original equipment would help.

Thanks for any help.

[wesk]

[DougK]

Wes

Thank you for the photo. If that is NOS then my configuration with the rings and chains and cotter pins are correct.

Doug