Update starter?

Keith · Post by **Keith** » Thu Apr 23, 2009 1:05 pm

Thanks Wes,

I was the one asking about a early m38 starter and ring gear engagement.
After reading and studying all the info & pics you sent me, I pulled the the cover off of the contacts and pulled the plunger out and found what I was missing the firts time. The small set screw in the end of the plunger hidding under the grease. loosened it, adjusted the plunger and tested a few times until it matched the specs you sent me, hooked up 24v and now it works perfectly. very simple with the right info!

Thanks again
Keith
9/51 M38

Post by **Ryan_Miller** » Thu Apr 23, 2009 7:27 pm

Hey,

We are glad you got her going. To help out our fellow jeeper is the whole purpose of this website.

Post by **wesk** » Sat Apr 25, 2009 12:35 pm

I have found over the many years I have been wrenching that reading the book first then turning the wrench will usually yield much better results.

Keith · Post by **Keith** » Sun Apr 26, 2009 4:53 pm

Absalutly!

Update starter?

Update starter?

absalutly!