[b]1967 M38A1 NOS Primer Kit Installation.[/b]

[glarock]

This is my first MV restoration project and I am stumped on the primer kit installation. I received an NOS kit with everything in it but the instructions. Also, my maintenance manuals or parts manuals dont paint a clearer picture for me on what goes where. Can someone please walk me through it or send some pictures? I would greatly appreciate it.

My jeep can be seen at www.onesmallearth.com

Thank you!

[wesk]

Hello Girard,






Remove the elbow fitting from the fuel inlet line on the fuel pump and install item 4 in this photo in the inlet prt of the fuel pump. Install the leg of the "T" on the #4 fitting. Put the elbow you removed from the pump inlet fitting and install it in the top of the "T". Insert the new #2 fitting in the bottom port of the "T". Connect the hand primer's suction line #5 to fitting #2. The other line #8 goes down the left side of the valve cover then up and over at the forward edge of the carb.

[glarock]

Thank you very much!!!

[miljeep52]

In the color picture Iam in need of #3 clamp support, need three to finish instal of vent system on my '52 Thanks Scott out

[wesk]

It's an AN742-X series clamp. Just Google AN742 and the - size is the tubing diameter at 1/16" each size. So for example if the tube is 1/4" that's 4/16" so you order a AN742-4. These mil specs were filled by many vendors and there were subtle differences between each vendors product and this was allowed.