Gear shift knob for M38

GeorgeMcKenzie · Post by **GeorgeMcKenzie** » Sat Sep 26, 2009 11:19 pm

I bought a knob for the gear shifter leaver for my M38 CDN . The leaver is about 3/8 " in diamiter . and the hole in the knob is about 1/8 " .This is a push on one so do I have to make the hole bigger or can it be forced on the leaver .This is the only M38 in my area so I could use some advice on this Thanks for any help George

Post by **Ryan_Miller** » Sun Sep 27, 2009 8:03 am

George,

Push it on, give it H%**!

GeorgeMcKenzie · Post by **GeorgeMcKenzie** » Sun Sep 27, 2009 9:28 pm

Thanks for the info .George

DJ · Post by DJ » Tue Sep 29, 2009 8:46 pm

A little off topic, does anybody else besides me have screw on knobs? Would be curious to se how many of each are out there.

DJ

Cacti_Ken · Post by **Cacti_Ken** » Fri Oct 02, 2009 7:00 pm

mine are screw on.

DJ · Post by DJ » Fri Oct 02, 2009 9:21 pm

Both my M38's have screw on.

DJ

skyjeep50 · Post by **skyjeep50** » Sat Oct 03, 2009 3:44 pm

My M38 has screw on knobs and my M38A1 has push on knobs. I did replace the knob on my A1 and the replacement knobs hole was a very small diameter - cram it on and it will hold tight. If you enlargen the hole it will be a loose fit and the knob could come off.
That's the hole knobby story!

Gear shift knob for M38

Gear shift knob for M38

Gear shift knob

Knobs