UJ grease nipples

Leo · Post by **Leo** » Sat Oct 03, 2009 3:04 pm

Hi,
I have been greasing up all the points on my NEKAF M38A1, read about the nipples being surrounded with a red paint circle, and lo and behold, when I cleaned off the old grease there they were!
The only npoints I couldn't get to were the UJ's on the front drive shaft, just impossible to angle the nozzle of the gun, even with flexi. Any tips? Can you fit longer nipples, or is there a special narrower nozzle?
Thanks

skyjeep50 · Post by **skyjeep50** » Sat Oct 03, 2009 3:48 pm

Did you try to rotate the shafts to a different position to gain access to the grease zerks? I've not had any problems greasing my M38A1.

Leo · Post by **Leo** » Sat Oct 03, 2009 3:58 pm

Hi Skyjeep,
Yes I did run it forward and back,but no joy.
Will try again next week.
Thanks

UJ grease nipples

UJ grease nipples

Zerks