LIFTING SHACKLE AND C-CHANNEL SET-UP FOR M38A1

Discussion topics on Willys Overland M series vehicles
Post Reply
User avatar
madmike
Active Member
Active Member
Posts: 249
Joined: Tue Apr 07, 2009 6:00 pm
Location: Mariposa, Ca.

LIFTING SHACKLE AND C-CHANNEL SET-UP FOR M38A1

Post by madmike »

I am installing the bumper/C-channel modification for the USMC jeeps on my 1961 A1 and in all the pictures I can access, I am unable to determine if the old shackles located inside the bumpers, go back on with the modification. Anyone with an original out there that could take a look, it would be much appreciated.

Mike
User avatar
53a1
Jeep Enthusiast
Jeep Enthusiast
Posts: 586
Joined: Tue Jun 24, 2008 6:00 pm
Location: Kern Co.

Post by 53a1 »

Mine looks like it was USMC direct and didn't have them but that doesn't mean much.
User avatar
Zane
Active Member
Active Member
Posts: 158
Joined: Sat Jun 30, 2007 6:00 pm

Post by Zane »

No, once you add the marine core rear crossmember the army style shackles wont go back on, the marine cross member/rear bumper has provisions for the marine core type shackles to go on the ends of the crossmember for side lifting
User avatar
madmike
Active Member
Active Member
Posts: 249
Joined: Tue Apr 07, 2009 6:00 pm
Location: Mariposa, Ca.

Post by madmike »

Thanks for the prompt reply men. I have a kit with the longer bolts and the larger lift assemblys with pins, etc. but did not know about the stock lifts. I'm ready to put this on and did not want to go the drill twice.

Mike
User avatar
wesk
Site Administrator
Site Administrator
Posts: 16469
Joined: Sun Apr 03, 2005 6:00 pm
Location: Wisconsin
Contact:

Post by wesk »

Your kit must have been missing the two pages of instructions:

Image

Image
Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100

Mjeeps photo album: http://www.willysmjeeps.com/v2/modules. ... _album.php
User avatar
madmike
Active Member
Active Member
Posts: 249
Joined: Tue Apr 07, 2009 6:00 pm
Location: Mariposa, Ca.

Post by madmike »

Very Good Wes. This site is awesome and yes, I did not get the instruction sheets. But I have one more question that is not addressed in the material so far. I received four lifting shackles, not two, and the information sheets do not specify front shackles replacement. Can I assume that I was sent too many shackles?
User avatar
wesk
Site Administrator
Site Administrator
Posts: 16469
Joined: Sun Apr 03, 2005 6:00 pm
Location: Wisconsin
Contact:

Post by wesk »

Read the instruction sheet more slowly. Especially the paragraph that tells you to remove the front shackle rings and discard them and install two new 5004 shackles then go to the rear paragraph that says the same thing about the original shackle rings. :wink:
Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100

Mjeeps photo album: http://www.willysmjeeps.com/v2/modules. ... _album.php
User avatar
madmike
Active Member
Active Member
Posts: 249
Joined: Tue Apr 07, 2009 6:00 pm
Location: Mariposa, Ca.

Post by madmike »

Yup. I missed that part by being in a hurry. So many questions...so little time. And 67 year old eyes don't help either.

Mike (Duh)
User avatar
Balvar24
Active Member
Active Member
Posts: 191
Joined: Fri Sep 04, 2009 6:00 pm

Post by Balvar24 »

Not that it matters, but my 63 doesn't have the USMC rear lifting rings, much like the 61 listed above.
Post Reply