Floor Drain Parts

dod03-52 · Post by **dod03-52** » Sat Dec 05, 2009 10:02 pm

Anybody out there have a good picture of the pieces and parts for the floor drain assy. The ORD 9 book is not much help.

Post by **wesk** » Sat Dec 05, 2009 10:47 pm

These have the rubber gaskets glued to them. I believe the early ones did not have the rubber gasket.

dod03-52 · Post by **dod03-52** » Sun Dec 06, 2009 6:11 am

Thanks Wes, what does the wingnut screw into? I have nothing attached to the floor for the threads to go into.

G740 · Post by **G740** » Sun Dec 06, 2009 7:25 am

The wing nuts in the photo are not correct.
They go into a weld nut attached to the floor in the center of the two larger holes the covers go over.
John

Post by **wesk** » Sun Dec 06, 2009 11:53 am

John, Does your replacement floor panels have the weld nut installed?

G740 · Post by **G740** » Mon Dec 07, 2009 6:28 pm

Our floors have all weld nuts and associated hardware in place where needed before we ship.
John

Post by **wesk** » Mon Dec 07, 2009 9:37 pm

Glad to hear that. Do you have an illustartion of a correct thumb screw?

Cacti_Ken · Post by **Cacti_Ken** » Sat Dec 19, 2009 8:33 am

Wes did you ever get a reply on the question of the correct thumb screw?

Post by **wesk** » Sat Dec 19, 2009 1:40 pm

No, John must be on Christmas break!

DJ · Post by DJ » Sat Dec 19, 2009 11:36 pm

Page 11 on his web site under M38 parts is a picture of them.

DJ

Floor Drain Parts

Floor Drain Parts

Floor drain parts

Wing nuts

Floor pans