Brake lights stay on.

Scott21 · Post by **Scott21** » Tue Nov 22, 2011 9:05 pm

Heat shield should be here tomorow. Replacing the head pipe and intermeadiat pipe too. they needed to be replaced and if i ordered them the shipping was free from Walcks.

Scott21 · Post by **Scott21** » Wed Nov 23, 2011 9:20 pm

New exhust pipes are in. Fit perfict, even into my militarized civi muffler. My 38 had a new muffler and I miged a military flange on it. How does the heat shield fit. Tapered end to the front or back. I never had one so I am not sure. Not to bad, ordered Monday installed by wednesday.

donthedickens · Post by **donthedickens** » Thu Nov 24, 2011 9:10 pm

Scott,
Send me a PM with your e mail. I have a picture of the heat shield I can send you, but it's not mine so I can't post it here.

donthedickens@aol.com

evanso1975 · Post by **evanso1975** » Fri Nov 25, 2011 1:06 am

Pointy end forward:

http://www.willysmjeeps.com/v2/modules. ... pic&t=3979

Post by **wesk** » Fri Nov 25, 2011 11:37 am

Careful. This photo from that link is correct.

The two photos further down the page are incorrect. The original tie plate for the master cylinder to the cross shaft must be flat against the master cylinder and the heat shield bracket goes on last closer to the engine.

Scott21 · Post by **Scott21** » Thu Dec 29, 2011 12:36 pm

Finally instaled heat shield and brake lights work fine. No brake drag either.