Photos Needed - M38A1 Pass Front Quarter Panel...

OKCM38CDN · Post by **OKCM38CDN** » Sat Jan 28, 2012 8:38 am

I am getting ready to start working on the M-38A1 I purchased in October...

A previous owner did a lot of bubba mods to the tub and I need to figure out what holes are good and what holes are bubba's... I can figure some out as they have threads on the inside, but others are just holes...

If I could get several photos of the passenger side cowl and quarter panel I can get started... I am in no rush to get this completed, however good photos would really help... I just want to do it correctly...

I have a couple of dings and dents that need attention also... I also have to cut the patch over the slave recepticle out and clean it up...

Thanks in advance...

OKCM38CDN · Post by **OKCM38CDN** » Wed Feb 01, 2012 4:49 pm

Bump...

Or don't you folks take photos any more????

madmike · Post by **madmike** » Wed Feb 01, 2012 7:22 pm

I have some photos of my 1961 tub after sand blasting. I have not been able to figure out the posting of photos on the gallery set up for me but have emailed photos from my computer to help others before. If you PM me with your email address I will do that for you. My tub did not have any mods done to it nor did it have after market stuff like a heater or radio. Might be what you need but yours is earlier I believe.

Mike

OKCM38CDN · Post by **OKCM38CDN** » Wed Feb 01, 2012 10:11 pm

Use the email tab at the bottom of my post to send me an email...

madmike · Post by **madmike** » Thu Feb 02, 2012 11:28 am

Message sent.

Headcase · Post by **Headcase** » Thu Feb 02, 2012 10:21 pm

If you were to post a picture of what you have we might be able to tell you better of what is good and what you should weld up.
I have afew pics I can post here its a 53 CDN you want the pass side fender and cowl eh?
Let me know and I can send you some or post here...But lets see what you got okay?
HC