Wiper motor position

Dave51 · Post by **Dave51** » Mon Aug 27, 2012 8:18 am

I have vacuum wipers on my M-38 and I believe the flat of the motor should be down but my manual handles are also down. They should be up I believe. Can the handles be switched?

RICKG · Post by **RICKG** » Mon Aug 27, 2012 8:24 am

Dave51 wrote:Can the handles be switched?

Piece of cake-pull the front mount plate and carefully knock out the small pin from the arm to shaft, reverse the arm and re-assemble.

Dave51 · Post by **Dave51** » Mon Aug 27, 2012 9:58 am

Thanks Rick, I found the pin but they are tight. I'll let them soak in WD40 and see if they will come loose.

RICKG · Post by **RICKG** » Mon Aug 27, 2012 10:13 am

support the shaft really well and lightly tap the pin with the appropriate size punch. mine slid right out.

wilfreeman · Post by **wilfreeman** » Mon Aug 27, 2012 5:19 pm

I tried to remove the ones on my original motors, but they wouldn't budge. I didn't even try on my replacement (m151) motors - I just mounted them upside down. I guess when I run out of stuff to work on I'll go back and start working on stuff like that.

Dave51 · Post by **Dave51** » Mon Aug 27, 2012 9:41 pm

Mine won't budge either. Winter project.

Wiper motor position

Wiper motor position

Re: Wiper motor position