Solex vs Carter Carburetor

Discussion topics on Willys Overland M series vehicles
Post Reply
User avatar
Deadguy
Jeep Enthusiast
Jeep Enthusiast
Posts: 776
Joined: Wed Jun 08, 2011 6:00 pm
Location: Bellmore, NY
Contact:

Solex vs Carter Carburetor

Post by Deadguy »

If I end up having to replace my carb, which is better? I know the Carter is more correct for an early M38A1, but some people say they are the worst carburetors ever made, and they are about twice the price.
1952 M38A1
Marine core reinforced rear bumper, military transistorized turn signal upgrade, arctic heater, 11" drum brakes, 200L PTO winch, Huffy overdrive, deep water fording kit, RT 68 vehicle mounted radio, Trac Locs front and rear.
www.danhenk.com
User avatar
RICKG
Jeep Legend
Jeep Legend
Posts: 1752
Joined: Mon Aug 30, 2010 6:00 pm
Location: SO IDAHO

Re: Solex vs Carter Carburetor

Post by RICKG »

Deadguy wrote: they are the worst carburetors ever made.
A well built, maintained and adjusted Carter YS950 is decidedly
NOT the worst carb ever made, however a wornout, poorly maintained
and maladjusted YS950 could rank right up there :wink:
keep 'em rollin'
RICKG MC 51986 DOD 01-52, '50 CJ3a
User avatar
wesk
Site Administrator
Site Administrator
Posts: 16467
Joined: Sun Apr 03, 2005 6:00 pm
Location: Wisconsin
Contact:

Post by wesk »

You are asking one of the oldest and most often asked question out there. A properly overhauled and adjusted Crater is the perfect all around carb for the M38A1 period. Solex and Pinto motorcraft carbs are band aids applied by folks without the where withal, money, time or aptitude to fix the problems.

Just search this and all the other pre 1972 jeep web sites and make your own informed decision.
Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100

Mjeeps photo album: http://www.willysmjeeps.com/v2/modules. ... _album.php
User avatar
timjuhl
Jeep Enthusiast
Jeep Enthusiast
Posts: 262
Joined: Sun Jun 26, 2011 6:00 pm
Location: "Thumb" of Michigan

Carbs

Post by timjuhl »

I've run Solex, Carter YF and Carter YS950 S carbs on my Jeep. Of the three, the YS seems to be the simplest design and in my limited experience works really well with the Hurricane engine in my M38A1. The YF (from a 62 CJ5) also worked really well but is a bit more complex . I found the Solex to work well although it tended to be cold blooded. In the cooler weather I found it to be a little harder to start and then needed to let it idle for a few minutes before driving. Once warmed up it was fine although I believe the Carter's give the Jeep a little more performance.

Any carb that is worn out is going to give you trouble. You can pay to get it rebuilt or buy a new Solex for about the same price. I decided to go with the YS and after a little repair, the one I have seems to be working well. Time will tell whether I made the right choice.

Tim
Tim Juhl
1952 M38A1
1946 Aeronca L16A Army Liaison Aircraft
User avatar
Deadguy
Jeep Enthusiast
Jeep Enthusiast
Posts: 776
Joined: Wed Jun 08, 2011 6:00 pm
Location: Bellmore, NY
Contact:

Post by Deadguy »

I got a rebuilt Carter from John at Midwest Military, and am sending him my old one for core value.
1952 M38A1
Marine core reinforced rear bumper, military transistorized turn signal upgrade, arctic heater, 11" drum brakes, 200L PTO winch, Huffy overdrive, deep water fording kit, RT 68 vehicle mounted radio, Trac Locs front and rear.
www.danhenk.com
skyjeep50
Jeep Enthusiast
Jeep Enthusiast
Posts: 606
Joined: Mon Feb 19, 2007 6:00 pm
Location: Illinois

Post by skyjeep50 »

Speaking as one of those "without the wherewithal, money, time or aptitude" :wink: , I installed a Solex on my M38 because I had one NIB I bought off of e-bay for half price. It was intended for another project but was sitting there unused. The military carb awaits rebuilding, I also have a basket case Carter for rebuilding as well. But the Solex has worked very well, NO adjustments right out of the box, easy to hook up - throttle, choke and hand throttle, no problems. Others may not have had the luck I have had but its worked for me. I'm not recommending a Solex, just reporting what I have found.
1951 M38
User avatar
53a1
Jeep Enthusiast
Jeep Enthusiast
Posts: 586
Joined: Tue Jun 24, 2008 6:00 pm
Location: Kern Co.

Post by 53a1 »

I've ran a Solex, YS and YF and they all work great.
'53 M38A1 X2
User avatar
wesk
Site Administrator
Site Administrator
Posts: 16467
Joined: Sun Apr 03, 2005 6:00 pm
Location: Wisconsin
Contact:

Post by wesk »

In virtually every testimonial you read on this topic the performance of the Solex was compared to that of a tired and/or poorly maintained/adjusted Carter.

I have played with all these carbs since the 70's and the Solex has no performance advantage over the properly rebuilt & adjusted Carter at all. And contrary to many claims it is not a "Bolt on" job. It is not difficult to modify linkage, plumbing and induction tubing but it certainly is not a bolt on.
Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100

Mjeeps photo album: http://www.willysmjeeps.com/v2/modules. ... _album.php
User avatar
Texbillhs
Contributor
Contributor
Posts: 134
Joined: Tue Apr 24, 2012 6:00 pm
Location: Pennsylvania -Avondale/Kennett Sq

Post by Texbillhs »

I rebuilt my Carter - still had problems and then when to a new Solex, which is still on the jeep, but in the end it was the fuel pump that caused the problem.

I had an idea, since jeeps are notorious for poor fuel mileage, to someday try to graft a throttle body and fuel injection. I have and old CJ2A to play with and I was looking at my Ford Escort's fuel system ...... just dreaming.
1952 M38
Post Reply