hole locations

circleburner12 · Post by **circleburner12** » Tue Jul 09, 2013 12:26 pm

needing the correct hole mounting location and dimensions for the rear reflector. installed a new rear panel and the needing the info. thxs

chrisk · Post by **chrisk** » Thu Jul 11, 2013 5:21 am

Hi circleburner12,
See my member album "sinrisnekaf"on page 8.
There is an image Dimensions Rear Panel page 2of2, the location of the reflector is outlined in red.
Chris

circleburner12 · Post by **circleburner12** » Thu Jul 11, 2013 11:32 am

thxs chrisk, unless im missing something, the dimensions you speak of on page 2 is for the jeep. im asking for the reflector mounting holes for the m100. thxs

chrisk · Post by **chrisk** » Fri Jul 12, 2013 1:48 am

Sorry, overlooked that it is a M100 trailer.
Chris

circleburner12 · Post by **circleburner12** » Fri Jul 12, 2013 10:07 am

thanks anyway.

jeepman · Post by **jeepman** » Fri Jul 12, 2013 11:39 am

Circleburner,I just when out and checked my 52 M100 rear panel.It just happens my reflectors are not reinstalled yet,Here are the dimensions I found.These are all measured to the center of the holes.The holes are 4 inches in from the side end of the rear panel,Note this is the end of the panel not the box side.The bottom hole is 2 and 15/16 inches up from the bottom edge of the panel itself not the frame rail.The top hole is 6 and 7/8 inches up from the bottom edge of the panel.Hope this helps.I would drill the bottom holes first then use your reflector to mark the top hole for a good fit.

circleburner12 · Post by **circleburner12** » Fri Jul 12, 2013 6:41 pm

jeepman thank you. thxs

hole locations

hole locations

hole locations

Hole Location