Some Ramsey 50 winch drum dimensions

Post by **wesk** » Tue Oct 22, 2013 10:26 am

Can anyone with the cable off their drum offer up these two measurements?

joebuck · Post by **joebuck** » Tue Oct 22, 2013 11:39 am

in the M38 1/4 Military Jeep Reference Guide by Miller on page 165 fig 20.3 .......there is a picture of a clean spool with this written on masking tape

11 x 3 1/2 R D

Post by **wesk** » Tue Oct 22, 2013 12:02 pm

That gives me the 3 1/2" drum diameter but does not clarify the 11" measurement as being one of the three following choices:

1-Between the outer edges of the drum flanges.
2-Between the inner edges of the drum flanges.
3-Between the inner edge of the two radius's that transition from the flat horizontal drum surface to the flat vertical flange surface.

Bill_F · Post by **Bill_F** » Tue Oct 22, 2013 5:38 pm

Sorry my jeep has been put away for the winter and has cable on it. I do need to take the cable off in the spring to shorten it some. If you don't have an answer by then I will take the measurements.

bbloom · Post by **bbloom** » Tue Oct 22, 2013 9:49 pm

Dimension B is 10 5/8 inches.

Post by **wesk** » Tue Oct 22, 2013 10:22 pm

Thanks Bill. Is your winch a 50 or 50R? Is it on the jeep now?

Bill_F · Post by **Bill_F** » Wed Oct 23, 2013 4:54 am

It is a 50 and is mounted in my jeep.

Bill_F · Post by **Bill_F** » Wed Oct 23, 2013 4:59 am

Some photos I took awhile ago, might not be very helpful however

bbloom · Post by **bbloom** » Wed Oct 23, 2013 5:46 am

Wes it's a 50R and mounted on the Jeep now. Jeep is about 80% completed. Hope to finish it over the winter.

Post by **wesk** » Wed Oct 23, 2013 10:05 am

Bill F, That sure looks like 10 5/8" on the distance between the drum flanges.

Bill B, Thanks. When you have a chance can you put together a group of detailed photos, especially those not see often from below the jeep and the left side of the engine back to the PTO and post them to your album here or email them to me?

bbloom · Post by **bbloom** » Wed Oct 23, 2013 10:24 am

Be glad to Wes. I didn't know I had an album here though.

Bill_F · Post by **Bill_F** » Wed Oct 23, 2013 10:44 am

I can also take photos of the whole setup in the spring. The only part I am missing is the pto shifter lock-out.

Post by **wesk** » Wed Oct 23, 2013 11:31 am

Your album is here: http://www.willysmjeeps.com/v2/modules. ... _album.php

bbloom · Post by **bbloom** » Fri Oct 25, 2013 8:06 pm

OK Wes pictures downloaded

Post by **wesk** » Fri Oct 25, 2013 9:51 pm

Bill B,
One classic M38. Awesome piece of work Bill!!!