trailer receptacle assy

Bretto · Post by **Bretto** » Sun Nov 24, 2013 8:25 am

I realized I never got the bracket, with the 3 protruding tabs, that sits behind the receptacle assembly and will be making one. But I was curious of what it's purpose was. The only thing I could think of was to somehow act as a guard?
Thanks RickG for pic, I plucked this from your gallery.
Thanks,
Brett

evanso1975 · Post by **evanso1975** » Sun Nov 24, 2013 8:35 am

That's the polarizing bracket. This old post may help:
http://www.willysmjeeps.com/v2/modules. ... polarizing

Bretto · Post by **Bretto** » Sun Nov 24, 2013 8:40 am

Thanks Owen.

Bretto · Post by **Bretto** » Sun Nov 24, 2013 11:25 am

Are the 2 side tabs slightly off of center? I can see that the middle tab is centered but the other 2 look a bit off to one side. And also are they all about 1" wide?
Thanks

Bretto · Post by **Bretto** » Tue Nov 26, 2013 4:23 pm

Turned out ok, B for effort.

Post by **wesk** » Tue Nov 26, 2013 9:02 pm

That's the original Willys installation and the TB 9-904-9 rotates that 90 degrees to the right (CW).

billybob · Post by **billybob** » Wed Nov 27, 2013 6:57 am

Darn it, just something else I have to copy [steal] from Bretto. Anyhow thanks for the good pictures.

Bretto · Post by **Bretto** » Wed Nov 27, 2013 8:49 pm

No problem

billybob · Post by **billybob** » Wed Nov 27, 2013 9:30 pm

Thanks again Bretto, I admire your pride in your work and your workmanship.