RAMSEY MOUNTING PLATES M-38

buzzk · Post by **buzzk** » Tue Dec 03, 2013 1:08 pm

ANYBODY HAVE THE MEASUREMENTS FOR THE MOUNTING PLATES TO FRAME ON A M-38 FOR THE WINCH THE PICS ON THE SITE ARE VERY HARD TO READ OR HAVE A SET FOR SALE THX BUZ K ST AUGUSTINE FL 757-403-9964

Post by **wesk** » Tue Dec 03, 2013 1:24 pm

Is this the drawing that is too hard to read?

You can fine tune the indicated dimensions by installing your frame and winch in the chassis then check needed measurements from the installation against the measurements in the drawings.

Post by **wesk** » Tue Dec 03, 2013 7:54 pm

That's is not my photo. I am not certain of the viewing angle of the tape versus the bracket so I dare not offer a guess as to actual length based on the tape. If you simply bolt the front and rear angles to your winch and set them in place it will be very easy to determine the needed measurements. You could also use a pair of dividers and a ruler and determine the needed measurement by comparison to the known measurements.

Note that the two brackets in the photo show different CM's compared to the tape which I believe is a visual error caused by the camera angle.

Conversions from CM to Inch can be done here:
http://www.convertunits.com/from/cm/to/inches