Tool Box lid catch

Cacti_Ken · Post by **Cacti_Ken** » Thu Aug 24, 2006 10:52 pm

What do the parts/ components look like for the tool box lid catch. I don't know what I am missing to fix it.

davem201m38 · Post by **davem201m38** » Fri Aug 25, 2006 7:20 am

These are all I have in my archive and my catch is pretty beat up.
Don't know if they help.

Not the best I know.
Dave.[/img]

Post by **wesk** » Fri Aug 25, 2006 12:15 pm

I believe the parts on the door are the Ring WO# 674956 ORD# 7375351, Washer ORD# 120393, washer WO# 674993 and Pin, cotter ORD# 119117. The catch which I believe is the striker on the box frame is WO# 674957 ORD# 7375169.

Post by **wesk** » Sat Aug 26, 2006 12:41 am

Cacti_Ken · Post by **Cacti_Ken** » Sat Aug 26, 2006 11:14 am

Ok, thanks,

My tool box lid has the boss still on it. I need the little guy that looks like 1/4 inch rod bent into a 90 degree that fits thru the boss and also the washers and ring which attach to it.

The box frame has a ring on top of it. Inside the box frame there is what is left of a piece that hangs down. I am not sure if it has rusted off some.
Can you tell?

Post by **Ryan_Miller** » Sat Aug 26, 2006 4:39 pm

Ken,

That is the catch for the latch. when you put the lid down you turn the handle and the "L" shaped latch turns to catch that ledge.

Cacti_Ken · Post by **Cacti_Ken** » Sat Aug 26, 2006 6:07 pm

Thanks Ryan, I thought I was going have to do something about that plate in the photo. I didn't know if was rusted off or what.

Post by **wesk** » Sun Aug 27, 2006 8:28 am

The striker I believe is a part of the box assembly since it is welded in place. The catch would be, I assume, the part on top of the box used to provide a means to pad lock the lid closed.