M38 Regulator shield dimensions.

DanS · Post by **DanS** » Fri Dec 12, 2014 7:12 am

I see the photos of this shield on Wes's album, but does anyone have a dimensional drawing of this part. Seems like it could be easily made. Thanks.

Dan

Bill_F · Post by **Bill_F** » Sat Dec 13, 2014 7:39 am

If you need one I have an extra

Xamon · Post by **Xamon** » Sat Dec 13, 2014 8:26 am

I need the dimensions for the shield and the mounts for item PO removed the whole thing and the battery tray to fit the chevy engine

DanS · Post by **DanS** » Sat Dec 13, 2014 12:24 pm

PM sent Bill.

Dan

DanS · Post by **DanS** » Sat Dec 13, 2014 12:24 pm

Xamon;

Wes has the dimensions and drawing for the mount in his photo album.

Dan

DanS · Post by **DanS** » Mon Dec 15, 2014 7:15 am

This posts seems to have gotten off track. I need the dimensions for the voltage regulator guard. Anyone?

Dan

4x4M38 · Post by **4x4M38** » Mon Dec 15, 2014 9:39 am

Is the part you need dimensions for the flat plate the mounts are bolted to?

Mine is still there if that is what you need. If there is an additional plate I don;t have that one.

Brian

Post by **wesk** » Mon Dec 15, 2014 11:23 am

Dan, Back on track

RICKG · Post by **RICKG** » Mon Dec 15, 2014 11:36 am

Dan, the best I could do while measuring the plate while mounted in the vehicle:
10-1/2" x 8" with the dubbed off corner being 45 deg, 2" x 2".

DanS · Post by **DanS** » Mon Dec 15, 2014 12:33 pm

Thanks Rick.

Dan

aforests · Post by **aforests** » Sun Feb 22, 2015 4:43 pm

I am trying to figure out if any of these bends in this regulator mounting base are supposed to be there, or if I should try to straighten all the bends to have two flat sides...

4x4M38 · Post by **4x4M38** » Sun Feb 22, 2015 5:33 pm

Aaron,
Two flat planes. Flat on top, flat on the side next to the engine.
Everything else is Bubba mods...