Crankshaft Pulley Guard Spacers
-
Mjfire1949
- Member
- Posts: 47
- Joined: Sun May 11, 2014 6:00 pm
- Location: Frisco, Texas
Crankshaft Pulley Guard Spacers
1952 M38, 4-134 L, 24 volt, Serial # 65666, North Texas. Does anyone know where I can purchase the spacers that fit the crankshaft pulley shield bolts? I dropped the pan to install a new pan gasket, and found that the previous owner has used two 1/2 nuts on each bolt for a spacer. Thanks in advance.
Mjfire
-
OKCM38CDN
- Jeep Enthusiast
- Posts: 530
- Joined: Thu Feb 16, 2012 6:00 pm
- Location: Del City, OK
-
wesk
- Site Administrator
- Posts: 16466
- Joined: Sun Apr 03, 2005 6:00 pm
- Location: Wisconsin
- Contact:
Or if you wish to fabricate from standard bushing stock:
Body Inside Diameter: 0.4665 inches minimum and 0.4685 inches maximum
Body Outside Diameter: 0.5615 inches minimum and 0.5635 inches maximum
Corner Shape: Square all corners
Material: Steel overall
Overall Length: 0.6865 inches minimum and 0.6885 inches maximum
Body Inside Diameter: 0.4665 inches minimum and 0.4685 inches maximum
Body Outside Diameter: 0.5615 inches minimum and 0.5635 inches maximum
Corner Shape: Square all corners
Material: Steel overall
Overall Length: 0.6865 inches minimum and 0.6885 inches maximum
Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Mjeeps photo album: http://www.willysmjeeps.com/v2/modules. ... _album.php
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Mjeeps photo album: http://www.willysmjeeps.com/v2/modules. ... _album.php