Bellhousing cable boot

[garcia63]

I will be replacing the cable boot to the bellhousing and noticed that there is some thread marks on the inside of the hold where the cable goes into the fork. I looked at the illustrations and could not find a part that goes in there.
What part would go there? I am trying to link a photo.

[wesk]

You can see the threaded nipple attached to the boot here:



This is the threaded nipple in the bell housing just above the circled stud.

You failed to indicate which model jeep you have.

If M38 ORD 9 SNL G-740 Page 50, lower view in Fig 02-2, Item X.

If M38A1 or M170 ORD 9 SNL G-758 Page 56, Item X.

[garcia63]

M38--thank you sir--Part Number 8328439 Clutch cable boot adapter would be the part I was looking for--already found it with a couple of vendors.