Gen Conn Pin-out

m38mc · Post by **m38mc** » Mon Jan 08, 2007 3:38 pm

Does anybody have the pin-out of the 3 pin connector on the Generator?
I need to know what A,B,C pins are.
Thanks

Post by **wesk** » Mon Jan 08, 2007 9:11 pm

A & C are both Armature pins. B is the field pin. The harnes shield is the ground connection between the regulator and the generator.

m38mc · Post by **m38mc** » Tue Jan 09, 2007 4:01 pm

Thanks Wes,
This is just what I was looking for.
Now off to the Generator repair shop.

m38mc · Post by **m38mc** » Wed Jan 10, 2007 3:16 pm

A couple of new bearings, a set of brushes, clean-up the armature and I am back into the driving mode.
Thanks again,