wiring for blackouts

[TOM-R]

guys I am finishing up the remainder of my wiring got 2 questions,
first can someone post or email me a pic of how to route the wire for the fender mounted blackout lite

second where can i get 2 plugs to fit the b/o lites in the grille? i am using mutt b/o lites with the water proof plugs thanks

[OKCM38CDN]

The rubber Packard connectors can be gotten from Saturn Surplus...

As for the routing they drop from the Headlight connections to the BO lights if I remember correctly...

Hope this helps...

[TOM-R]

the grille lites i can route it is the fender 1 i do not know how to route it into the engine compartment, do i put a hole in the fender and run it along the hat channel and then punch a hole in the wheel well to get it into the engine compartment where i have the junction block?

[Kendall]

The wires go along the top of the fender (there should be a hole for a small hold-down clamp on the fender) and then drops down along the engine side of the fender in front of the horn and joins the rest of the wiring harness from there. Hope this helps, Kendall

[TOM-R]

thanks, i got a hole in the fender that accesses the inside of the hat channel think i will run the wire in there just need to figure on how to fish it out