A1 Rear Panel Footman Loop Question

w30bob · Post by **w30bob** » Tue Aug 15, 2017 8:22 am

Hi Guys,

The previous owner of my jeep ground off one of the welded-on footman loops on the top of the tail panel to move the spare tire carrier up and over a bit to make room for a rear winch install. I'm trying to find the part number for that footman loop to make sure I get the correct one..........but can't find it in the ORD. Wes' pictures are great, but I didn't see any part numbers listed. The only weld-on footmans in the ORD are listed for the axe/shovel stowage and all the others list bolts and nuts under them implying they are bolt-on, not welded on. So can someone enlighten me as to where the part number for these rear panel footmans is located?

thanks,
bob

Post by **wesk** » Tue Aug 15, 2017 10:27 am

Bob, I do not believe they were ever listed separately. They came as a welded part of the Rear Panel Weld Assy. You're best bet is to use the standard 1" loop (H002-7697591)and weld it on. Or compare the other two welded loops on the rear hat channel to the other welded loops on the jeep and select one of the other welded ones if they match.

w30bob · Post by **w30bob** » Tue Aug 15, 2017 3:25 pm

Thanks Wes............that would explain it.

regards,
bob

STXM38A1 · Post by **STXM38A1** » Wed Aug 16, 2017 8:20 pm

These are from a previous post quite a while ago.

http://www.willysmjeeps.com/v2/modules. ... el+footman

Couldn't find the post I thought I remembered.

w30bob · Post by **w30bob** » Wed Aug 23, 2017 7:08 am

Hi Warren,

Thanks for the pic !!!

regards,
bob