chassis reinforcement M38

xog250 · Post by **xog250** » Thu May 24, 2018 7:54 pm

Hi, my name is Sergio
I want to thank Ryan and Wes and all this group of friends who love jeep Willys.
I have a cj3A that I have been conditioning which did not have any identification plate but it came with an M38 windshield and I decided to take it to the M38.
One of the improvements I'm about to make is the reinforcements at the ends of the chassis. Which I decided to copy them from the M38.
To finish them well I would lack the measures to locate the nuts where the winch is mounted.
The nuts I assume are for tornillos screws. If I'm wrong, they could clarify it.
I leave this drawing so you can give me the measurements

A = D = G =

B = E = H =

C = F =

Since already very grateful
Sergio

Post by **wesk** » Fri May 25, 2018 2:39 am

I have several photos in my photo album that may be helpful:

xog250 · Post by **xog250** » Fri May 25, 2018 8:54 am

Thank you for your quick response, maybe I could not sniff well that is what I need, the photos you posted had views (you recommend always visit the photo gallery to not answer on the same subject)
I would be specifying the inner side.

Post by **wesk** » Fri May 25, 2018 9:52 pm

This should help. Between the poor lighting in my storage building and the dark colors it is the best I can do right now.