Accellarator pedal adjustment.

Ryan · Post by **Ryan** » Thu Mar 15, 2007 7:40 am

My M38 does not go to full throttle when my foot pedal is pressed all the way down. I was thinking that I could add some washers in between the throttle lever on the block and the throttle pedal and that should give me the extra throttle I need. Anybody else have any suggestions?

maeserik · Post by **maeserik** » Thu Mar 15, 2007 8:27 am

i put washers between the leverplate and the block, about 0.16 inch - 4 mm. This sets the ac.pedal a little higher, which is easyer to drive

I had the same problem, maybe the tube is not exactly on the frame, a little bit backwards?

at full trottle the pedal just do not touch the floor

Erik

OKCM38CDN · Post by **OKCM38CDN** » Thu Mar 15, 2007 4:46 pm

The rod from the carb to the accelerator pedal should be threaded to allow for adjustments... I have about 4 inches of thread on the rod on my M-38...

Hope this helps...

maeserik · Post by **maeserik** » Mon Mar 19, 2007 2:04 am

after put washers between the leverplate and the block i adjusted all with the thread on the rod so the acc. pedal was in the highest possible position