The PO of my '51 M38 had a set of IH Lock-O-Matic locking hubs on the Dana 25. I am rebuilding from the knuckles out. When I removed the Locking hubs I found them trashed on the inside - these are not going back on!
In my spare parts pile I found a pair of olive drab 6 hole, 10 spline drive hubs with hub caps. When I removed the hub caps, I found a rubber gasket (or o-ring) around the base of the hub where it mates to the hub cap. These may have been supplied by the PO when I bought it, but I am not sure
Does the rubber gasket confirm that it is for the M38 series? Are these a "go" for my Dana 25??
Thanks Jeff
1951 M38 restoration project - Flightline Jeep MC 23923 DoD 6-51
1954 M-100 Trailer USMC Dunbar Kapple s/n M-750759 DoD 1-54
1947 Willys CJ2A - Harvest Green
1954 Ford F-100 Parts chaser - blueprinted Y-Block
Southeast Florida
If they fit they will work. The original installation did not have the outer seal 8329732 and the inner seal was a 500128 in the M38's 1951 ORD 9 but updated to 8329731 in the M38's 55 ORD 9.
