M38A1 CDN 3 1970 FRAME SPECS.

jeep_teck · Post by **jeep_teck** » Wed May 16, 2007 5:09 am

HEY GUYS ...

NIP TUCK. On an already existing m38a1 1970 cdn 3...Frame was crooked so fixed that last night and noticed that the inside fender passenger side was not clearing the top shock support.What was the difference in size from small . to big fenders. and would somone have the specs for the frame..I seem to have it all fixed up but I would need the center to center spec for the front bumber attaching holes of the bumper....I think that the bumper is not original.
thank you

mark.

cmpman · Post by **cmpman** » Wed May 16, 2007 6:24 am

I have a Cdn 3. I could make whatever measurements you need. I can't say I have ever seen a specifications listing for these frames however.

The Cdn 3 frames had one good upgrade to them. They had the frame boxed in the area around the rear spring front mounting point. I used to see cracking on the earlier frames in this area, never saw that on a Cdn3.

Post by **wesk** » Wed May 16, 2007 9:26 am

Hello Mark,
The specs for the A1 frame are in TM9-8015-2.