PLUG drain, front floor pan

RonD2 · Post by **RonD2** » Fri Jan 22, 2021 6:15 pm

Thanks Keith! That sure explains it and is very nice to know!

Post by **wesk** » Fri Jan 22, 2021 10:47 pm

There you go Ron. Drive the old one out and see if it lays flat and rolls even.

Keith, Do you have the associated Willys/Kaiser drawing?

WillysMotors · Post by **WillysMotors** » Sat Jan 23, 2021 12:04 am

Yes, I have the Engineering Drawing.

I will try to find it and email it to you.

Post by **wesk** » Sat Jan 23, 2021 12:52 am

Thanks

RonD2 · Post by **RonD2** » Sat Feb 27, 2021 6:35 pm

Finally got around to punching the 3/4-inch drain hole in my tool box floor, along with a photo of the NOS rubber plug and the tool that I used to cut the hole.