M38 front wheel bearings identification

[arisLgr]

Hi all!
Can someone please advise me if those TIMKEN will fit ok my M38's front wheel hubs?
Thanks, Aris
here they are

[RonD2]

Hi Aris,
Pretty sure those are the differential carrier bearings, not the hub bearings.

Good luck!

[BBDE]

These should be right for the MUTT and will fit M151 & M416 wheel hub's,
not for Willys M38 / M38A1


Just my opinion



Frank

[arisLgr]

Thanks guys, I wish the parts manual had the specifications!

[BBDE]

It has all infos and specs you need.

Take a look to page 254
Group-13 Wheels, Hubs and Drums
1311- Wheels, Hubs and drums

There you find the Bearings (Cup & Cone) whith the specs.

So you come to Timken 18590 for the Cone
and 18520 for the Cup.

Kegelrollenlager 18590-18520-Q-TIMKEN, In-dia 41.275 mm,
out-dia 73.025 mm, thk. 16.667 mm (found on the Web)

Or look here for an older Post:
http://www.willysmjeeps.com/v2/modules. ... ic&t=12666

[wesk]

M38 front axle Hub & axle inner bearing cones, cups, & seals

Front hub bearing cones, cups & seals
The 4 bearing cones (2 in each hub) ORD# 705423, FSN 3110-100-3526
https://www.wbparts.com/rfq/3110-00-100-3526.html
18590 F0704 THE TIMKEN COMPANY
The 4 cups for the hubs: ORD# 706836, FSN 3110-100-0532
https://www.wbparts.com/rfq/3110-00-100-0532.html
18520 60038
TIMKEN CORPORATION, THE

2 seals for hub inner side: ORD# 8329731, NSN 5330-00-505-6700
Hub inner seals 2 ea. ORD# 8329731 NSN 5330-00-505-6700
https://www.wbparts.com/rfq/5330-00-505-6700.html
49530 79150
DANA AUTOMOTIVE SYSTEMS ROUP, LLC DBA DANA SEALING PRODUCTS
___________________________________________________________

Inner axle bearing cones, cups and seals

Inner axle 2 bearing cones: ORD# 705438, NSN 3110-00-100-3537
https://www.wbparts.com/rfq/3110-00-100-3537.html
24780 60038
TIMKEN CORPORATION, THE

Inner axle 2 bearing cups: ORD# 706849, NSN 3110-00-100-0543
https://www.wbparts.com/rfq/3110-00-100-0543.html
24721 60038
TIMKEN CORPORATION, THE

Inner axle 2 bearing seals: ORD# 500030,


Timken National Seals 40576S
Nitrile Oil Seal - Solid, 1.187 in Shaft, 2.000 in OD, 0.250 in Width, 4S Design, Nitrile Lip Material
Mi Item #: 01299999

Specifications
________________________________________
Solid / split: Solid Seal type: Single Lip without Spring
Shaft diameter: 1.187 in Maximum shaft surface speed: 2000 fpm
Outside diameter: 2.000 in Misalignment tolerance: 0.005 in
Width: 0.250 in Construction description: Non-Spring Loaded Seal For Grease Retention
Design type: 4S Typical application: General Purpose
Lip material: Nitrile